Browse terms related to these fuel groups:alternative fuels|coal|electricity|natural gas|nuclear|petroleum|renewable
Dry (coal) basis: Coal quality data calculated to at heoretical basis in which no moisture is associated with the sample. This basis is determined by measuring the weight loss of a sample when its inherent moisture is driven off under controlled conditions of low temperature air-drying followed by heating to just above the boiling point of water (104 to 110 degrees Centigrade).
Dry bottom boiler: No slag tanks at furnace throat area. The throat area is clear. Bottom ash drops through the throat to the bottom ash water hoppers. This design is used where the ash melting temperature is greater than the temperature on the furnace wall, allowing for relatively dry furnace wall conditions.
Dry gas: See Dry natural gas.
Dry hole: An exploratory or development well found to be incapable of producing either oil or gas in sufficient quantities to justify completion as an oil or gas well. Also see Well.
Dry hole charge: The charge-off to expense of a previously capitalized cost upon the conclusion of an unsuccessful drilling effort.
Dry hole contribution: A payment (either in cash or acreage) that is required by agreement only if a test well is unsuccessful and that is made in exchange for well test and evaluation data.
Dry natural gas: Natural gas which remains after: 1) the liquefiable hydrocarbon portion has been removed from the gas stream (i.e., gas after lease, field, and/or plant separation); and 2) any volumes of nonhydrocarbon gases have been removed where they occur in sufficient quantity to render the gas unmarketable. Note: Dry natural gas is also known as consumer-grade natural gas. The parameters for measurement are cubic feet at 60 degrees Fahrenheit and 14.73 pounds per square inch absolute. Also see Natural gas.
Dry natural gas production: The process of producing consumer-grade natural gas. Natural gas withdrawn from reservoirs is reduced by volumes used at the production (lease) site and by processing losses. Volumes used at the production site include (1) the volume returned to reservoirs in cycling, repressuring of oil reservoirs, and conservation operations; and (2) gas vented and flared. Processing losses include (1) nonhydrocarbon gases (e.g., water vapor, carbon dioxide, helium, hydrogen sulfide, and nitrogen) removed from the gas stream; and (2) gas converted to liquid form, such as lease condensate and plant liquids. Volumes of dry gas withdrawn from gas storage reservoirs are not considered part of production. Dry natural gas production equals marketed production less extraction loss.
Dry production: See Dry natural gas production.